Hannover 2020 – wissenschaftliches Programm
Die DPG-Frühjahrstagung in Hannover musste abgesagt werden! Lesen Sie mehr ...
Bereiche | Tage | Auswahl | Suche | Aktualisierungen | Downloads | Hilfe
Q: Fachverband Quantenoptik und Photonik
Q 28: Precision Measurements and Metrology (Gravity)
Q 28.6: Vortrag
Mittwoch, 11. März 2020, 12:15–12:30, f435
Suitable optomechanical oscillators for an all optical coherent quantum noise cancellation exeriment — •Bernd Schulte1,2, Daniel Steinmeyer1,2, Mariia Matiushechkina1,2,3, Margot Hensler Hennig1,2, and Michèle Heurs1,2,3 — 1Max Planck Institute for Gravitational Physics and Institute for Gravitational Physics, Hannover, Germany — 2Quantum Frontiers — 3PhoenixD
Optomechanical detectors have reached the standard quantum limit in position and force sensing where backaction noise, caused by radiation pressure noise, starts to be the limiting factor for sensitivity. One strategy to circumvent measurement backaction, and surpass the standard quantum limit, has been suggested by M. Tsang and C. Caves [1] and is called Coherent Quantum Noise Cancellation (CQNC). This scheme can be viewed as coupling a second oscillator with an effectively negative mass (see J. Junker) to the one subject to quantum radiation pressure noise and thus realizing a quantum non-demolition measurement. After an introduction of the idea and the requirements for CQNC this talk will be focused on the oscillator susceptible to quantum radiation pressure noise. A Michelson interferometer was used for characterisation of the mechanical linewidth and resonance frequency of the oscillator. We discuss the measurement principles intended to determine mechanical and optical properties of our devices (membrane-in-the-middle vs. membrane-at-the-end setup). These set-ups could also be used to shift the mechanical properties via the optical spring effect to satisfy CQNC requirements. [1] M. Tsang and C. Caves, Phys. Rev. Lett. 105 ,123601, 2010.